Make your own free website on Tripod.com

_________________________________________ Midsouth Rescue Technologies

Driver's Frontal Airbags

Home
Live Training Classes
Supplemental Restraint Systems
Introduction to Safety Restraint Systems
How Airbags Work
Driver's Frontal Airbags
Passenger's Frontal Airbags
Head Protection Airbags
Side Impact Airbags
Occupant Positioning Airbags
Roll-Over Protection
EMS Concerns
Vehicle Fires and New Technology
Introduction to Vehicle Fires
Airbags and Airbag Inflators Involved in Fire
Compressed Gas Struts
Bumper Struts
Plastic Fuel Tanks
Magnesium Fires
Attacking Vehicle Fires
Hybrid Vehicles
Emergency Response Guides
General Rescue Procedures
Self Study Courses
Public Education
Up-Coming Events
Photo Gallery
Videos
Links
Sign Our Guest Book
Memorial

 
Driver's Frontal Airbags

This page includes:
  • Single stage driver's frontal airbags
  • Dual stage driver's frontal airbags
  • Smart airbags (Driver's Frontal) 
  • Seat position sensors.
For more advanced information see the power point presentation:
Airbags and New Technology Part 1&2. (coming soon)

airbag001.jpg
Click picture to enlarge

This is a single stage driver’s frontal airbag. Enlarge the picture and notice the single plug in the center of the inflator module.
 
These were the first airbags installed in vehicles and were used by some manufacturers through the 2006 model year. Though they operate the same, very few look alike, each one is shaped to fit a particular steering wheel design.
 
 

driverairbairbag.jpg
Click picture to enlarge

The inflation zone for these is 10 inches from the center of the steering wheel to any part of the driver's body.
 
Rescuers should never put themselves or any type of equipment between this airbag and the victim.
 
Since the early 1970s rescuers have been taught that if the airbag is deployed, there is no more danger, it can not deploy a second time.
 
 
Warning! This is no longer true!
 
 
 

airbagparts004.jpg
Click picture to enlarge

This is a driver's dual stage frontal airbag. Enlarge the picture and notice the two plugs in the center of the inflator module.
 
These have two individual inflator units that can be deployed individually or both at the same time.
 
Though these have been used for several years, federal standards require them in every vehicle from 2007-up.

Warning! Rescuers must never enter the 10 inch inflation
 zone of any driver's frontal airbag.

img_0405_edited-1.jpg
Click picture to enlarge

 
 
From the front side, which is what the rescuer would be looking at, many of these look identical.
 
When installed in the vehicle it is impossible to tell which one is single stage or which is a dual stage.
 
 
 

airbag007.jpg
Click picture to enlarge

Being bolted to the steering wheel, rescuers could never see this view.
 
With each inflator unit being able to deploy individually, many times one side will still be loaded, even though you see the nylon bag hanging down.
 
Warning! It is impossible to visually tell if both sides have deployed or not.

img_0409_edited-1.jpg
Click picture to enlarge

 
Even looking at the back side, it is impossible to tell which side is deployed.
 
This airbag was deployed under controlled conditions for a classroom display. One side is still loaded, but even looking at the plugs, it is impossible to tell which side deployed.

 

Warning! Today we must treat every frontal air bag
as if it was a non-deployed one.
 
Never put yourself or any piece of equipment 
between the air bag and your victim.

.

Second Generation or
Smart Airbags
 
Smart airbags, is simply a name given dual stage airbag systems; because by the uses of sensors and controls they can regulate their own deployment.
 
One of the sensors used with the driver's frontal airbag is the seat position sensor. There are many different types of these sensors but they all do the same thing. They measure the distance between the seat and the airbag deployment zone, or front of the steering wheel.
This allows the control module to deploy the airbag according to the occupant's proximity to the inflation zone. 

sensor.jpg
Click picture to enlarge

These sensors are mounted in the seat adjustment tracks.
 
Most of these sensors operate in four zones. Zone #1 being the closest to the steering wheel and zone #4 being the furthest away.
Depending on the zone the seat is in at the time of the crash, the control module can; not deploy the airbag, deploy only one side, or deploy both sides.

As rescuers; we have always been taught that if a vehicle is equipped with electrically operated seats, to move the seat as far back as possible before disconnecting the battery.
Because of the operation of these sensors, many extrication instructors disagree on this procedure and both sides can be right in their teaching. (Details in the in depth studies).
 
As a general rule of thumb; Consider the size of the occupant, if you have sufficient room to perform your rescue without compromising the vitim's spinal alignment, simply adjust the back rest portion of the seat, to assure they are out of the inflation zone. If not then move the seat, but be sure that it is moved as far as possible; because this action will change the path of deployment in the control module, setting the airbag up for a second deployment should an accidental charge of electricity enter the system. 

Frequent Ask Questions

fig_1-5-2.jpg
Click picture to enlarge

Many questions arise about why these airbags deploy in some crashes and not in others. Being a frontal impact airbag, these will only deploy in a front end type collision. The vehicle must be impacted either straight on or within a 30 degree angle from either side of the center line of the vehicle.
 
Also these systems depend on crash sensors that must experience a certain amount of deceleration, or sudden slowing of the vehicle. Many times a vehicle that sets higher than the one it hits, will impact above the crash sensors and the thinner metal of the hood and fenders will absorb the impact, not allowing the crash sensor to experience enough deceleration. (This is covered in the in depth studies)

Another question is about the use of steering wheel covers:
 
This one gives us a very good example of how we develop our training and why we so desperately need a change in our training. Take a look at conversations we find on major fire/rescue forum boards.
 
The forum below is a very good example of the desperate need for training and the lack of funding for it.

Does anyone use airbag / steering wheel covers during extrication? I am not sure what companys make this product with the exception of Halmatro.
------------------------------------------------------------------------------
Capt, I have toyed with this subject matter recently, and did some experiementing during training. Being that few departments have the actual tested products, including ours, I did some field testing with some homemade devices. We took seatbelts out of vehicles and made a simple device by weaving them together to make a 4 point connection which diverted the force, we used the simple rescue rope technique, but, the one we found that worked the best was an idea that I came up with while working out in the gym. I saw the weightlifting belts and how the design of it could be used, with the portion that protects the lower back being larger and oval. I took one out to the training ground and the connection was simple and extremely strong. The leather belt had a good coverage and the buckle had 4 reinforced points of contact. None of these procedures are sanctioned by any formal organization, but I figured something was better than nothing........I think we will find the approved products working their way into our cache of equpment as a necessity with the increasing technological aspects of todays vehicle market.....Thanks
 
Thats a great idea and a heck of alot cheaper than purchasing the airbag covers. Specially if you are on a tight budget.. Way to go in adapting and overcoming in the efforts to protect yourself and fellow brothers and sisters.. I will take this idea back to my department and try it out. Thanks for the input.. And hey ya know if you find a way to modify the design of that back brace and still be effective you could always market it...
----------------------------------------------------------------------------------------------

steeringwheelcovers_jpg_w300h232.jpg

 
There is equipment on the market to protect us from the driver’s frontal air bags. Some departments have them and SOPs or SOGs in place for using them, but let’s take a look at what they do.

 

First they are only protecting us from one of the 37 danger that you will see in the in depth studies.

Secondly, they can factor in human error by not being applied properly. In the in depth study, you will find that the second part of our tactic of working With the system, protects us from this human error. Rushing to an MVA at 3:00 am, have you ever made a mistake? Let’s say we did make a mistake, now we have a projectile traveling at 2-3 hundred mph directly into an already injured victims’ face. Now we have a real problem, this projectile just took the liability off of the manufacture and put it on you and your department, because it was not properly installed.

 

Thirdly, we can build a false sense of security allowing us to put our self in the inflation zone

steeringwheel_jpg_w300h225.jpg
Click picture to enlarge

Finally, when these covers were being developed in the late ’80s and early ‘90s, we were faced with one single stage airbag per vehicle, and steering wheels with a steel ring inside them. Today we may be faced with as many as twelve airbags per vehicle and new steering wheel construction that may not be able to hold some types of these covers
 
 
 

steeringwheel_1.jpg
Click picture to enlarge

Many steering wheels no longer have a steel ring inside them. Most of the newer models have an aluminum tube as shown Above. These tubes are actually made to bend, in order to lessen chest injuries in a sever crash. The force of an airbag deployment against the cover can easily bend one, as seen here releasing the cover as a projectile. With the dual stage airbags of today we have the risk of a second deployment, doubling the chance of this happening. 

   

.
           Contact us  /  About us  /  Advertise here  /  Site Map  /  Disclaimers           
_____________________________________________________________________________________________________________
Midsouth Rescue Technologies - PO Box 1830 Springtown, Texas 76082

If this site has helped you please help us support this website. No donation is too small.